Installing the Front Splash Guards HONDA ODYSSEY

TOOL REQUIRED
Stubby Phillips screwdriver
Diagonal cutters
Pushpin
INSTALLATION
NOTE:
•These instructions show the left splash guards
being installed. The same procedure applies to
installing the right splash guards.
•Clean and wax the areas to be covered with a
high-quality paste wax.
Installing the Front Splash Guards
1.Turn the steering wheel all the way counter clockwise to provide access to the left front fenderwell.
2.Remove the two self-tapping screws from the left
front inner fender.

While holding the left splash guard against the
fender, tighten the self-tapping screws in the order
shown.
6.Turn the steering wheel all the way clockwise and
repeat in steps 2 through 4 to install the right front
splash guard.
Installing the Rear Splash Guard
If the vehicle is not equipped with a rear inner fender,
go to step 13; otherwise, continue with step 7.
7.Using a stubby screwdriver, remove the left rear
inner fender (three self-tapping screws).

Hold the left rear splash guard against the
fenderwell and check that there is no clearance
between the splash guard and rear bumper. Tighten the three self-tapping screws in the sequence shown.
12.Repeat steps 7 thru 11 to install the right rear
splash guard.

DOWNLOAD

This entry was posted in Uncategorized. Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s