2009 Odyssey Roof Box, Short INSTALLATION INSTRUCTIONS

SUPPLIES REQUIRED
Isopropyl alcohol
Shop towel
ROOF BOX
ADHESIVE
SEAL
ADHESIVE
SEAL
Put this information in the glove box with the vehicle owner’s manual.
INSTALLATION
NOTE:
•Be careful not to damage the roof and other finished surfaces of the body when installing the roof box.
•The maximum load capacity for this product is
110 lb (50 kg); approximate product weight is 29 lb
(13 kg).
•Do not allow the combined weight of the accessory
and cargo to exceed the carrying capacity of the
roof rack.
•Honda roof racks or crossbars are required to install
the roof box.
1.Open the roof box. Attach an adhesive seal over
each of the unused mounting holes along the
bottom of the box. The seals will help prevent
water from entering the roof box.

Using isopropyl alcohol on a shop towel, clean four brackets B where the small pads will attach. Remove the adhesive backings from the small
pads and attach them to the brackets B.

Under the roof box, insert a bolt through bracket
B, through the plate and into the predrilled hole in
the bottom of the roof box. Install bracket B with
the cutout facing the outside.

LOADING THE ROOF BOX
•Load weight equally on both sides to minimize imbalance. Do not overload the roof box, the
maximum allowable load is 110 lb (50 kg).
•Loads must be secured with the straps to
prevent them from sliding. Check the fasteners
at regular intervals.

DOWNLOAD

This entry was posted in Uncategorized. Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s