Bomz Racing 94-97 Honda Accord Cold Air Intake Installation Guide

Removal of Factory Intake
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable. 2. Pull upwards to remove the air inlet duct.
3. Depress the stock clamp and remove the stock crank case vent hard line
from the stock air intake tube.
4. Unclip the vent, throttle cable and the MAP Sensor electrical connect from
the stock intake tube.
5. Loosen the hose clamp on the throttle body.
6. Loosen the clamp on the resonator then disconnect the flange.
7. Remove the four bolts on the upper air cleaner assembly, then pull upwards
to remove the upper air cleaner assembly and stock intake tube.
8. Remove the two bolts that secure the lower air cleaner assembly.
9. Unclip the stock vacuum hose from the side of the lower air cleaner
assembly.
10. Pull upwards to remove the lower air cleaner assembly.
11. Disconnect and unclip the vacuum hose from the resonator.
12. Remove the screw that secures the solenoid to the resonator.
13. Remove the two bolts that secure the resonator.
14. Pull upwards to release the resonator from the stock grommet, then remove
the resonator (VTEC only).
15. Remove the vacuum hose from the solenoid (VTEC only).
16. Raise the vehicle and support it with jack stands then remove the bolt on
the lower valance.
17. Remove the two push clips on the inner wheelhouse valance.
18. Remove the two push clips on the lower valance.
19. Pull the valance down.
20. From below the vehicle, loosen and remove the first bolt on the air cleaner
resonator.
21. From the side of the vehicle loosen and remove the second bolt on the
resonator.
22. Pull firmly downward to remove the stock resonator.
Install of Intake
23. Install the provided reducer and clamps onto the throttle body and tighten.
24. Install the intake tube and slid the crank case vent hard line into the vent
on the tube, then slide the tube into the reducer on the throttle body.
25. Tighten the clamp on the intake tube.
26. Apply the edge trim the hole on the inner fender.
27. Install the provided rubber mounted stud into the stock air cleaner mounting bracket.

DOWNLOAD

This entry was posted in Uncategorized. Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s