OBD2 Diagnostic Port Ford Installation

Plug the module into the diagnostic port. The diagnostic port is under the dash, below and to the left of the steering column. Secure the device up under the dash where it will
not be in the way.
IMPORTANT: Wait at least 15 seconds after key is on
(about the time it takes for the security light to turn off)
before starting engine.
Function light will flash quick when it is communicating,
then will flash slowly when it is done.
IMPORTANT: If you are using a chip programer, or when
the vehicle is taken to a repair center, it is recommended that
you first unplug the DPF-R module.
OPTIONAL: Unbolt the factory diagnostic port connector,
and bolt the DPF-R pass thru connector in its place.
EXHAUST NOTES: If you are doing your own exhaust
mod, it is important to place all sensors (except dpf pres-
sure) back into the exhaust. The sensors require a bung or
nut welded on the pipe with 12mm 1.25 threads. Reference
the stock pipe for location.

DOWNLOAD

This entry was posted in Uncategorized. Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s